Jones Z-630 Sewing Machine Parts
New parts for your machine below. Choose a foot, belt, bobbin or needle, then check out with PayPal or card.
Jones Z-630 Bobbin Winder Ring Tyre
Replacement rubber ring for the bobbin winder.
Jones Z-630 Rubber Stretch Belt
Replacement drive belt to restore smooth machine running.
Jones Z-630 Motor, Belt & Foot Control Set
Foot control to start, stop and vary sewing speed.
Jones Z-630 Metal Bobbins x 10
Pack of 10 sturdy metal bobbins, ready to wind and sew.
Jones Z-630 Shuttle Hook
Replacement hook that forms the lockstitch with the bobbin thread.
Jones Z-630 2 Packets of 10 Organ Assorted Needles
Two packs of Organ needles in mixed sizes for everyday sewing.
Jones Z-630 Bobbin Case
Holds the bobbin and controls lower-thread tension.
Jones Z-630 Walking Foot & Guide & Instructions
Feeds thick layers evenly so seams stay matched. Guide and instructions included.
Jones Z-630 Ruffler / Pleating Foot
Creates neat gathers and pleats in one pass.
Jones Z-630 Zig Zag Presser Foot
Everyday foot for zig zag stitching and light decorative work.
Jones Z-630 Adjustable Invisible Zip Foot
Sews concealed zips close to the teeth for a tidy finish.
Jones Z-630 Adjustable Zip / Zipper Foot
Sews standard zips and edged trims right beside the teeth.
Jones Z-630 Hinged Teflon Zip Zipper Foot
Non-stick zip foot that slides over leather, vinyl and sticky fabrics.
Jones Z-630 Non-Stick Zig Zag Teflon Foot
Non-stick zig zag foot for leather, vinyl and other sticky fabrics.
Jones Z-630 Adjustable Sequins Ribbon Foot
Guides sequins, ribbon or braid so you can sew them on neatly.
Jones Z-630 Free Hand Embroidery / Darning Foot
For free-motion embroidery and darning with the feed dogs lowered.
Jones Z-630 Free Motion Embroidery / Quilting Foot
Large opening for free-motion embroidery, quilting and creative work.
Jones Z-630 Free Motion Quilting Foot - Open Toe
Open front gives a clear view while free-motion quilting.
Jones Z-630 Applique Foot
Clear view for applique work and satin-stitch edges.
Jones Z-630 Fringe Tailor Tacking Foot
Forms fringe loops and tailor tacks for marking or trim.
Jones Z-630 Roller Foot
Rolls over leather, vinyl and other fabrics that stick or drag.
Jones Z-630 3 Strand Multi Cording Foot
Holds up to three cords for neat decorative cording.
Jones Z-630 Adjustable Blind Stitch Foot
Sews almost invisible hems on skirts, trousers and curtains.
Jones Z-630 Bias Tape Binding Foot
Feeds bias tape so you can bind raw edges in one pass.
Jones Z-630 Gathering Foot
Gathers fabric as you sew — ideal for ruffles and fullness.
Jones Z-630 Bias Binder Binding Foot
Folds bias binding and stitches it onto the fabric edge.
Jones Z-630 5 Groove Pintuck Foot
Twin-needle pintucks with five grooves for neat spacing.
Jones Z-630 9 Groove Pintuck Foot
Twin-needle pintucks with nine grooves for finer spacing.
Jones Z-630 Button Hole Foot
Helps you sew neat, evenly sized buttonholes.
Jones Z-630 Button Sew On Foot
Holds the button steady while you stitch it in place.
Jones Z-630 Open Toe Buttonhole Foot
Open toe for a clear view when placing buttonholes.
Jones Z-630 Slide Buttonhole Foot
Sliding foot for measured buttonholes of a consistent length.
Jones Z-630 Open Toe Embroidery Foot
Open front so you can see clearly while embroidering.
Jones Z-630 Knit Foot
Helps feed stretch and knit fabrics with less puckering.
Jones Z-630 Overcast Edging Foot
Neatens raw edges with an overcast stitch to reduce fraying.
Jones Z-630 Multicord Foot 5 Hole
Guides up to five cords for decorative multi-cord stitching.
Jones Z-630 6mm Felling Foot
Forms neat flat-fell seams about 6mm wide.
Jones Z-630 Edge / Joining Stitch In A Ditch Foot
Joins fabric edges or stitches neatly in the ditch for binding and quilting.